Isuzu N Series 2008 Owner's Manual page 252

4-124
CONTROLS AND INSTRUMENTS
CAUTION
• Even a 4WD vehicle does not exempt you from safe driving practices. Operate
the accelerator pedal, steering wheel and brake pedal with the same level of
caution as when driving a standard rear-wheel drive vehicle.
A part-time 4WD model can be switched between 2WD and 4WD operation using the
4WD switch. In addition, the transfer gear control switch changes between the "HIGH"
and "LOW" ranges.
The freewheel hubs are devices that allow the front wheels and the drive shaft to be
manually connected and disconnected.
CAUTION
• Whenever driving in 4WD mode, confirm that the knobs on the freewheel hubs
are set to the "LOCK" position.
• Do not press the 4WD switch when driving with the knobs on the freewheel
hubs in the "FREE" position. Doing so could cause the transfer case to fail.
ADVICE
• Do not set the knobs midway between the "FREE" and "LOCK" positions.
• In order to ensure sufficient lubrication of the front-wheel drive system, drive
approximately 20 km (12 miles) every month with the left and right freewheel
hubs in the "LOCK" position.
• The knob of the left and right freewheel hubs can become hot after driving.
• Whenever setting the freewheel hub in the lock or free position, always do so
on both sides of the vehicle.
2008N_sec04-2_print2.indd 124
Four Wheel Drive (4WD) Model
Part-time 4WD Model
Freewheel Hub
V
3/09/2008 5:31:57 PM