Isuzu N Series 2008 Owner's Manual page 255

Transfer LOW indicator light
ADVICE
• Do not operate the transfer gear control switch while driving. Be sure to bring
the vehicle to a stop and operate the switch while depressing the clutch pedal.
NOTE
[Part-time 4WD model]
• If the 4WD switch is placed in the "OFF" position, pressing the "LOW" side of
the transfer gear control switch does not put the vehicle into the 4WD mode.
• The transfer low indicator light does not come on unless the vehicle is in the
4WD mode (the 4WD switch is placed in the "ON" position).
2008N_sec04-2_print2.indd 127
CONTROLS AND INSTRUMENTS
Transfer Gear Control Switch
V
This switch is used to change between the
"HIGH" range (high speed) and the "LOW"
range (low speed) of the transfer case.
1. Make sure that the vehicle is stopped
and depress the clutch pedal.
NOTE
• The clutch pedal must be depressed
before the transfer gear control
switch can become active.
2. Press the "HIGH" side or "LOW" side
of the switch. When the "LOW" side of
the switch is pressed, the transfer low
indicator light comes on.
HIGH : Press this side for normal driving
on a general road or highway.
LOW : Press this side for driving on
a snowy road, icy road, steep
slope or rough terrain.
3. Make sure that the transfer low
indicator light is on and then start
driving.
4-127
3/09/2008 5:32:02 PM