Isuzu N Series 2008 Owner's Manual page 410

7-64
SERVICE AND MAINTENANCE
Brake system warning light
2008N_sec07-2_print2.indd 64
7. Loosen the bleeder screw to let the
brake fluid containing air bubbles flow
into the container and then tighten the
bleeder screw immediately.
8. Release the brake pedal slowly.
Repeat Steps 6 and 7 until the fluid
from the tube no longer contains air
bubbles. After bleeding, install the
rubber cap in position.
CAUTION
• While bleeding, ensure that the fluid
level in the brake fluid tank is not
below the "ADD" line.
• If the engine is not running during
air bleeding, the brake booster may
be adversely affected.
9. After you finish the bleeding for each
wheel, press the brake pedal to check
that the brake system warning light
does not come on.
3/09/2008 5:53:11 PM