Isuzu N Series 2008 Owner's Manual page 217

NOTE
• The 1st start mode cannot be selected in the manual mode.
If the manual mode is selected (the gearshift lever is moved from the "D"
position to the "M" position) after the 1st start switch is pressed, the 1st start
mode is suspended and the 1st start mode indicator light goes out.
When the mode is changed from the manual mode back to the auto mode
(the gearshift lever is moved from the "M" position to the "D" position), the 1st
start mode is reestablished and the 1st start mode indicator light comes on
again. However the gear position that was selected in the manual mode is still
retained. To enable automatic gear shifting to take place, drive the vehicle and
then stop it, or press the 1st start switch again to re-select the 1st start mode, or
return the transmission to manual mode to make it shift into 1st gear and then
change to the auto mode.
• When you place the starter switch in the "LOCK" or "ACC" position and restart
the engine, the mode returns to the normal start mode (2nd start mode).
ECONO mode indicator light
2008N_sec04-2_print2.indd 89
CONTROLS AND INSTRUMENTS
ECONO Mode
You can improve fuel economy if you select
the ECONO mode when the vehicle is
driven with the transmission in the auto
mode (automatic gearshift mode). When
you press the ECONO mode selector
switch, the ECONO mode is selected and
the ECONO mode indicator light comes on.
4-89
3/09/2008 5:31:43 PM