Isuzu N Series 2008 Owner's Manual page 547

2008N_sec08_print2.indd 27
IN CASE OF EMERGENCY
4. Disconnect the connector for the turn
signal light and then remove the light.
5. Disengage the rubber seals from the
two projections at the bottom of the
headlight. Remove the four bolts.
Then disconnect the connector for the
headlight, remove the clearance light
unit, and disconnect the headlight
leveling connector. Then remove the
headlight assembly.
ADVICE
• When removing the headlight
connector, pull out the connector
while holding the centre portion of
the rubber boot. If the headlight
connector is pulled out without
holding the centre portion of the
rubber boot, the bulb will lift up and
when the connector is removed,
the bulb can hit the reflector by the
reactive force of the retaining clip,
resulting in the breakage of the bulb.
8-27
4/09/2008 8:14:27 AM