Isuzu N Series 2008 Owner's Manual page 132

4-4
CONTROLS AND INSTRUMENTS
Make sure that the switches, including those for the windshield wiper, light control and
air conditioner, are in the "OFF" position.
Turn the starter switch to the "ON" position to check that the warning and indicator
lights turn on normally and the fuel level is proper.
CAUTION
• If your vehicle is equipped with a manual transmission, firmly engage the
parking brake when you sit in the driver's seat before starting the engine. Also,
be sure to start the engine while pressing the clutch pedal and after making
sure that the gearshift lever is in the "N" position.
• If your vehicle is equipped with a AMT system, firmly engage the parking brake
when you sit in the driver's seat, check that the gearshift lever is in the "N"
position and the shift indicator shows "N", and firmly press the brake pedal
before starting the engine.
• If you lean through the window from outside of the vehicle to start the engine,
the vehicle may start moving if the gearshift lever is in any position other
position than "N". This is very dangerous. Never start the engine that way.
2008N_sec04-1_print2.indd 4
Starting the Engine
Starting the Engine
• Do not keep the starter switch in
the "START" position for more than
about 10 seconds. Operating the
starter for too long might cause
battery failure or might result in
overheating and even a fire.
Starter Switch → Refer to page 4-60
WARNING
3/09/2008 5:27:59 PM