The transfer gear case oil level must be checked and it must be changed according to
the Maintenance Schedule.
Oil surface
2008N_sec07-2_print2.indd 117
SERVICE AND MAINTENANCE
Transfer Gear Case Oil
Maintenance Schedule
Checking the Oil Level
Oil level plug hole
Oil level
(lower edge of
oil level plug hole)
LNU770SH015101
V
→ Refer to page 7-159
1. Remove the oil level plug.
2. Check that the oil level is up to the
lower edge of the oil level plug hole.
• If the oil level is too low, add oil
through the oil level plug hole.
3. Fasten the oil level plug to the
specified torque.
Plug tightening torque
39 N·m (4.0 kgf·m/29 lb·ft)
ADVICE
•
Any dirt on the plug should be wiped
off before installing it.
7-117
3/09/2008 5:53:53 PM