Isuzu N Series 2008 Owner's Manual page 260

4-132
CONTROLS AND INSTRUMENTS
PTO indicator light
2008N_sec04-2_print2.indd 132
Switch-type PTO
To Engage the PTO
1. Fully pull up the parking brake lever,
and with the vehicle at a complete
stop, set the gearshift lever in the "N"
position. Then, start the engine.
2. Press the PTO switch. The warning
buzzer will begin making short,
repeated beeps, and the PTO
indicator light in the instrument panel
will come on.
3. The buzzer pattern will change to
short, slow beeps, and the clutch will
automatically engage.
4. Operate the special equipment's
control switch.
To Disengage the PTO
Press the PTO switch. The warning
buzzer will begin making short, repeated
beeps, and the PTO indicator light in the
instrument panel will go out. Then, the
buzzer will stop.
LNU740SH001201
• Before starting the vehicle, you
should confirm the following.
- The special equipment is in a safe
condition for driving.
- The PTO switch is in the "OFF"
position.
SA
CAUTION
3/09/2008 5:32:05 PM