Isuzu N Series 2008 Owner's Manual page 468

7-122
SERVICE AND MAINTENANCE
2008N_sec07-2_print2.indd 122
Refilling
1. Securely connect the oil pipe and oil
hose, and then refill the reserve tank
with the specified power steering fluid.
2. When the reservoir tank is filled with
the fluid up to the specified level, wait
for 2 to 3 minutes to allow the fluid
level to lower.
3. Without running the engine, fully turn
the steering wheel in both directions a
few times.
4. Lower the vehicle and start the
engine. While running the engine at
idle, fully turn the steering wheel in
both directions a few times. If you do
not hear any abnormal sounds, the
system has been properly bled.
CAUTION
• While refilling the system, keep
the reserve tank full of the fluid by
making additions as necessary to
prevent air from getting into the
hydraulic system.
Bleeding
If you hear any abnormal sounds when
you turn the steering wheel, air has gotten
trapped in the hydraulic system. Follow the
steps below to bleed the system.
1. Apply the parking brake firmly and
chock the rear wheels.
2. Apply the head of the jack to the
jacking point firmly.
3. Raise the vehicle until the front
wheels are completely clear of the
ground.
3/09/2008 5:53:56 PM