Isuzu N Series 2008 Owner's Manual page 103

ADVICE
• Should you lose the remote control unit, please contact your Isuzu Dealer.
• After locking the doors using the remote control unit, be sure to check that they
are locked by pulling the door handles.
• Avoid getting water on the remote control unit, dropping it, hitting it against
another object, or stepping on it; otherwise, the remote control unit could
malfunction.
• Do not leave the remote control unit on the dashboard or any other surface
where the unit might be exposed to high temperatures (exceeding 60°C/140°F).
Doing so may result in shorter battery life or malfunction of the remote control
unit.
• Repeatedly locking and unlocking the doors using the remote control unit 10
or more times in succession will trigger the protection circuit in the system,
preventing the unit from working. If this happens, wait for a while. The system
will then work normally.
• If the keyless entry system fails to operate normally, lock and unlock the doors
using the key and have the system inspected by your Isuzu Dealer.
NOTE
• The lock or unlock buttons on the remote control unit must be fully pressed for
more than 1 second to work.
• If you do not open any doors within about 30 seconds after pressing the unlock
button to unlock the doors, the automatic locking function of the system will lock
the doors again to prevent theft.
• In areas near a TV tower, electric power plant, radio station, etc. or under any
conditions involving strong electrical disturbances, the remote control unit
operating range might change or the keyless entry system might not work.
• The keyless entry system does not operate in the following cases:
- The starter switch is in the "ON" position.
- The key is inserted in the starter switch.
- One of the doors is open.
2008N_sec03_print2.indd 5
DOORS, WINDOWS AND SEATS
3-5
3/09/2008 4:35:42 PM