Isuzu N Series 2008 Owner's Manual page 199

Windshield Wiper and Windshield Washer Switch
To use the windshield wiper and washer switches, the starter switch must be in the
"ON" position.
(Off)
Lever position
Wiper state
2008N_sec04-1_print2.indd 71
CONTROLS AND INSTRUMENTS
Windshield Wiper Switch
(High speed)
(Low speed)
(Intermittent)
MFU8Z0SH017801
Intermittent
V
Stopped
(Light rain)
ADVICE
• The safety system may work to stop
the wiper when excessive load is
applied on the motor. In this case,
turn the switch to the "OFF" position
and, a few minutes later, check to
see if the wiper is back to normal
operation. If the wiper frequently
stops operation, refrain from using
it and contact the nearest Isuzu
Dealer.
• Before operating the wiper, ensure
that the wiper rubber is not stuck
on to the windshield. If the wiper
rubber is stuck to the windshield and
you still operate the wiper, the wiper
may break or the wiper motor may
fail.
• Do not operate the wiper on a dry
windshield surface. Otherwise, the
windshield surface may sustain
damage. Always use the windshield
washer when wiping a dry glass
surface.
The windshield wiper switch has the
following positions, which correspond to the
states of the wiper.
Low speed
(Moderate rain)
4-71
High speed
(Heavy rain)
3/09/2008 5:29:01 PM