Isuzu N Series 2008 Owner's Manual page 261

PTO indicator light
2008N_sec04-2_print2.indd 133
CONTROLS AND INSTRUMENTS
Switch-type PTO
To Engage the PTO
1. Fully pull up the parking brake lever,
and with the vehicle at a complete
stop, set the gearshift lever in the "N"
position. Then, start the engine.
2. Depress the clutch pedal fully, and
after waiting for a short time, press
the PTO switch.
At this time, the PTO indicator light in
the instrument panel will come on.
• If the PTO switch is set to the "ON"
position immediately after pressing
down the clutch pedal, a gear
grinding noise may occur or the
PTO may not engage. Operating the
switch before the vehicle has come
to a complete stop can also have
the same consequences.
3. Slowly remove your foot from the
clutch pedal.
4. Operate the special equipment's
control switch.
LNU740SH001201
M/T
ADVICE
4-133
3/09/2008 5:32:06 PM