7-54
SERVICE AND MAINTENANCE
WARNING
•
When fitting the element case, be careful not to let the O-ring become caught in
the screw threads. This could cause a fuel leak and start a fire.
ADVICE
•
Be sure to use an Isuzu genuine fuel filter element.
•
Replace the gaskets when replacing the filter element.
•
Dispose of the replaced filter element in a method conforming to the regulatory
requirements in your country.
WARNING
•
After changing the fuel filter element, operate the engine to check that there are
no leaks around the filter. Fuel leaks could cause a fire.
2008N_sec07-1_print2.indd 54
8. Install the element case.
Element case tightening torque
30 - 36 N·m (3.1 - 3.7 kgf·m/22 - 27 lb·ft)
9. Tighten the drain plug and connect
the water separator switch connector.
10. Bleed air from the fuel system.
Bleeding the Fuel System
→ Refer to page 8-15
3/09/2008 5:47:48 PM