Isuzu N Series 2008 Owner's Manual page 253

2008N_sec04-2_print2.indd 125
CONTROLS AND INSTRUMENTS
"FREE" Position
When a freewheel hub's knob is in the
"FREE" position, the wheel is disconnected
from the drive shaft.
This position should be used for driving in
2WD mode.
"LOCK" Position
When a freewheel hub's knob is in the
"LOCK" position, the wheel is connected to
the drive shaft for 4WD operation.
This position must be used for driving in
4WD mode.
• Whenever driving in 4WD mode,
ensure that the knobs on the left
and right freewheel hubs are set to
the "LOCK" position. (Even when
the 4WD switch is turned "ON" for
a viscous-coupling, torque split
4WD model, driving in 4WD mode
is possible only when the knobs on
the freewheel hubs are set to the
"LOCK" position.)
• If the left and right freewheel hubs
are set to the "FREE" position and
the front wheels are disconnected
from the drive shaft during driving
in 2WD mode, rotation of the front
wheels will not be transferred to the
front drive system. As a result, noise
and friction levels can be reduced
for more economic driving.
NOTE
4-125
3/09/2008 5:31:59 PM