Isuzu N Series 2008 Owner's Manual page 268

4-140
CONTROLS AND INSTRUMENTS
2008N_sec04-2_print2.indd 140
When Leaving the Dump Body Raised
CAUTION
• When the dump body is to be left
in the raised position for cleaning,
inspection or the like, always
position the vehicle on a level
surface, fully engage the parking
brake, apply chocks to the wheels,
ensure that the dump body is empty
and support the dump body using a
safety bar, safety posts or the like to
prevent the body from falling.
• Wheel chocks and safety posts
must both be used when performing
inspections or maintenance with
the dump body left in the raised
position.
• Ensure that only persons authorized
to work on the vehicle can enter the
area below the dump body.
1. Place the dump control lever located
in the cab in the "UP" position, and
make sure that the lever is locked in
place.
2. Always stop the engine when the
dump body reaches the highest
possible position.
3. Insert a safety bar to support the
dump body in place.
Before working underneath the raised
dump body, always apply chocks to
the wheels to prevent the vehicle from
moving and support the dump body
with safety posts to prevent the dump
body from falling.
3/09/2008 5:32:10 PM