Isuzu N Series 2008 Owner's Manual page 409

2008N_sec07-2_print2.indd 63
SERVICE AND MAINTENANCE
3. Remove the cap from the brake fluid
tank, and then add brake fluid to the
"MAX" level mark on the tank.
Maintain this level throughout
bleeding by adding brake fluid as
necessary.
4. Bleed the brake hydraulic system part
by part in the following sequence:
Right-hand drive:
Left rear wheel → Right rear wheel →
LSPV (model with LSPV only) → Left
front wheel → Right front wheel
Left-hand drive:
Right rear wheel → Left rear wheel
→ LSPV (model with LSPV only) →
Right front wheel → Left front wheel
5. Detach the rubber cap from the
bleeder screw (1). Wipe the bleeder
screw clean. Attach one end of a
vinyl tube to the bleeder screw and
put the other end in a clear container.
Fill the container with the brake fluid
to about one-third (1/3) of its capacity.
6. Press the brake pedal a few times
and keep it pressed.
7-63
3/09/2008 5:53:10 PM