Isuzu N Series 2008 Owner's Manual page 138

4-10
CONTROLS AND INSTRUMENTS
NOTE
• When you turn the starter switch to the "ON" position, the odometer/trip meter
shows what was displayed the last time you turned the switch to the "LOCK" or
"ACC" position.
• You can set the odometer to display on the odometer/trip meter each time you
turn the starter switch to the "ON" position. To do this, turn the starter switch to
the "LOCK" or "ACC" position while the odometer is being displayed, and then,
with the select / reset knob pressed, turn the starter switch to the "ON" position.
Within 3 seconds after turning the switch to the "ON" position, turn the starter
switch back to the "LOCK" or "ACC" position. Follow the same procedure to
cancel the setting.
2008N_sec04-1_print2.indd 10 3/09/2008 5:28:04 PM