Isuzu N Series 2008 Owner's Manual page 220

4-92
CONTROLS AND INSTRUMENTS
Condition and alarm type
AMT oil temperature is
abnormally high.
While in manual mode, the
vehicle was driven at low
speed in a higher gear. *
AMT emergency switch is in
the "ON" position.
The AMT adjustment switch
was operated.
An attempt is made to shift
into a gear that will cause
engine r/min to be too high
(manual mode).
An attempt is made to shift
into a gear that will cause
engine r/min to be too low
(manual mode).
* : The gear is automatically shifted down into an appropriate gear to prevent a failure due to an excessive
rise in oil temperature. At the same time, the buzzer sounds to notify the driver that this gear shift has
taken place to prevent the oil temperature from rising excessively.
2008N_sec04-2_print2.indd 92
AMT
warning light
Warning
buzzer
Flashes —
Short,
— repeated
beeps
Flashes —
One-time,
—
short beep
Continuous
—
beep
Short,
— repeated
beeps
AMT Warning Light
Corrective action
Stop the vehicle at a safe
place, place the gearshift lever
into the "N" position and run
the engine at idle until the AMT
warning light goes out.
Choose a suitable gear when
driving in manual mode.
Turn the AMT emergency
switch "OFF".
—
Place the gearshift lever into
the "D" position and drive with
an appropriate gear selected.
(Automatic gearshifts will not
occur.)
Place the gearshift lever into
the "D" position and drive with
an appropriate gear selected.
(Automatic gearshifts will not
occur.)
SA
→ Refer to page 4-44
3/09/2008 5:31:44 PM