Changing the AMT Clutch Oil
Change the AMT clutch oil according to the Maintenance Schedule.
ADVICE
•
After changing the AMT clutch oil, check that the oil level is correct by following
the instructions in the preceding "Checking the Oil Level" section.
•
Drained oil must be disposed of in a method conforming to the regulatory
requirements in your country.
2008N_sec07-2_print2.indd 111
SERVICE AND MAINTENANCE
Changing the Oil
Drain plug
MFU770SH011101
Maintenance Schedule
→ Refer to page 7-159
1. Place a container beneath the drain
plug.
2. Tilt the cab.
3. Pull out the dipstick.
4. Remove the drain plug to discharge
the oil into the container.
NOTE
•
AMT clutch oil cannot be completely
drained because a certain amount
remains in the fluid coupling and
hydraulic circuits.
5. Install the drain plug by tightening it to
the specified torque.
Drain plug tightening torque
29 - 49 N·m (3.0 - 5.0 kgf·m/22 - 36 lb·ft)
6. Fill the clutch with new oil through the
dipstick guide tube.
7. Check the oil level according to the
"Checking the Oil Level" section.
Checking the Oil Level
→ Refer to page 7-110
7-111
3/09/2008 5:53:50 PM