Isuzu N Series 2008 Owner's Manual page 172

4-44
CONTROLS AND INSTRUMENTS
ADVICE
• If this warning light comes on, have your vehicle inspected as soon as possible
at the nearest Isuzu Dealer.
• If this warning light flashes while driving, the AMT oil is abnormally hot. Pull
off to a safe place well clear of traffic as soon as possible. Do not start driving
again until the warning light goes out.
2008N_sec04-1_print2.indd 44
AMT Warning Light
Transfer LOW Indicator Light
SA
This warning light should remain on for
approximately 2 seconds after the starter
switch is turned to the "ON" position, and
then should go out.
This warning light should flash when the
AMT emergency switch is placed in the
"ON" position, and should go out when the
switch is placed in the "OFF" position.
AMT Warning Light and Warning Buzzer
Operation
→ Refer to page 4-91
V
This indicator light comes on when the
transfer gear control switch is pressed on
the "LOW" side.
Transfer Gear Control Switch
→ Refer to page 4-127
ADVICE
• Stop the vehicle before operating
the switch.
V
3/09/2008 5:28:41 PM