Isuzu N Series 2008 Owner's Manual page 196

4-68
CONTROLS AND INSTRUMENTS
ADVICE
• Do not leave the hazard warning flasher operating for an extended time
period with the engine stopped. Otherwise, the battery may go dead, making it
impossible to restart the engine.
2008N_sec04-1_print2.indd 68
Rear Fog Light Switch
When the light control switch is placed in
rear fog indicator light comes on. Use this
feature in low visibility such as in fog.
When the Bulb Does not Come On
Hazard Warning Flasher Switch
The hazard warning flasher is used to
signal other vehicles that your vehicle
is stationary on the road because of an
accident or component failure.
With the starter switch in any position,
when this switch is pressed, all of the turn
signal lights and the turn signal indicator
lights flash to signal an emergency. To
turn off the hazard lights, press the switch
again.
LNU740SH002501
V
, the rear fog lights come on and the
WARNING
• When replacing a rear fog light
bulb, do not use one of a wattage
larger than the specified wattage.
Otherwise, the wiring may be
burned.
→ Refer to page 8-24
3/09/2008 5:28:59 PM