Isuzu N Series 2008 Owner's Manual page 264

4-136
CONTROLS AND INSTRUMENTS
CAUTION
• The dump control lever cannot be secured in the "Temporary Stop" position.
This position must be used only to stop raising or lowering of the dump body
temporarily.
• If the dump control lever is set in the "Temporary Stop" position in order to hold
the dump body in an intermediate position for a considerable period of time,
there is a danger that the dump body may suddenly rise or fall. This action is,
extremely hazardous and must be avoided. When the dump body is to be held
in the raised position, ensure that it is fully raised, stop the engine, fix the dump
control lever in the "UP" position, and support the dump body by a safety bar.
2008N_sec04-2_print2.indd 136
To Temporarily Stop the Dump Body
Shown with a thick line in the drawing at
left is the lever position to temporarily stop
the dump body during raising or lowering.
Never leave the driver's seat while placing
the lever in this position.
CAUTION
• The dump control lever cannot be
secured in this position using the
lock button.
LNU740SH009701
To Raise the Dump Body
Shown with a thick line in the drawing at
left is the lever position to raise the dump
body.
In addition, when the dump body is to be
left in a raised position, secure the lever in
this position and support the dump body by
a safety bar.
LNU740SH009801
3/09/2008 5:32:08 PM