Isuzu N Series 2008 Owner's Manual page 214

4-86
CONTROLS AND INSTRUMENTS
NOTE
• When it is necessary to keep the speed of the vehicle very low, as when
reversing it onto a platform, you can utilize the creeping effect of the
transmission to move the vehicle smoothly using only the brake pedal, not by
using the accelerator pedal.
CAUTION
• When leaving the driver's seat, be sure to place the gearshift lever into the
"N" position, make sure that the shift indicator displays "N" and firmly set the
parking brake.
ADVICE
• When the vehicle is stopped, do not keep depressing the accelerator pedal with
the gearshift lever placed in "D", "M" or "R" while depressing the brake pedal.
Doing so may cause a failure.
• When stopping the vehicle on a slope, be sure to fully apply the brakes.
Keeping the vehicle stopped by depressing the accelerator pedal to produce a
strong creeping effect may cause a failure.
NOTE
• When stopping the vehicle to wait for a traffic light, it is recommended that you
place the gearshift lever into the "N" position for improved fuel economy.
2008N_sec04-2_print2.indd 86
To Stop the Vehicle
1. Press the brake pedal with your
right foot to slow down and stop the
vehicle. No special gear shifting is
required.
After the vehicle has stopped, the
gear is automatically shifted into the
starting gear in both the manual mode
and auto mode.
2. While the vehicle is stopped, place the
gearshift lever into the "N" position.
When the vehicle must be stationary
for several minutes, set the parking
brake.
3/09/2008 5:31:41 PM