Isuzu N Series 2008 Owner's Manual page 475

Bleeder screw
2008N_sec07-2_print2.indd 129
SERVICE AND MAINTENANCE
Operating the Jack
Raising the Vehicle
1. Place the jack immediately below
the jacking point and ensure that it is
upright.
The jack must be placed on a flat,
solid surface.
Front Wheel Jacking Points
Rear Wheel Jacking Points
Jacking When a Front Tyre Is Flat
2. Turn the head of the jack to extend
it to the height of the jacking point.
Turn it counterclockwise to extend.
3. Insert the jack handle into the socket.
Before jacking up, use the notched
end of the jack handle to turn the
bleeder screw fully clockwise.
4. Move the jack handle gently up and
down to extend it slightly.
5. Confirm that the jack is in good
contact with the jacking point, and
MFU770SH010301
then continue to raise the vehicle.
7-129
→ Refer to page 7-130
→ Refer to page 7-131
→ Refer to page 7-132
3/09/2008 5:54:03 PM