Accessing The Diagnostic Features; Signal I/O - Teledyne T200H User Manual

Operating Instructions

4.13.1. ACCESSING THE DIAGNOSTIC FEATURES

EXIT returns
to the main
SAMPLE
display
At this point EXIT
returns
to the PRIMARY
SETUP MENU
From this point
forward, EXIT returns
to the
SECONDARY
SETUP MENU

4.13.2. SIGNAL I/O

Note
126
To access the DIAG functions press the following buttons:
SAMPLE A1:NXCNC1=100PPM
< TST TST > CAL
SETUP X.X PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE
SECONDARY SETUP MENU
SETUP X.X
COMM VARS DIAG
SETUP X.X ENTER DIAG PASS: 818
8 1 8
DIAG SIGNAL I / O
NEXT ENTR
DIAG ANALOG OUTPUT
PREV NEXT ENTR
The signal I/O diagnostic mode allows to review and change the digital and analog
input/output functions of the analyzer. See Appendix A-4 for a complete list of the
parameters available for review under this menu.
Changes to signal I/O settings will remain in effect only until the signal I/O menu
is exited. Exceptions are the ozone generator override and the flow sensor
calibration, which remain as entered when exiting.
Teledyne API - Model T200H/T200M Operation Manual
NOX=XXX.X DIAG
SETUP PREV
DIAG
PREV
EXIT
DIAG
PREV
EXIT
DIAG
PREV
ENTR EXIT
DIAG
PREV
EXIT
DIAG
EXIT
PREV
ANALOG I / O CONFIGURATION
NEXT ENTR
DISPLAY SEQUENCE CONFIG.
NEXT ENTR
OPTIC TEST
NEXT ENTR
ELECTRICAL TEST
NEXT ENTR
OZONE GEN OVERRIDE
NEXT ENTR
FLOW CALIBRATION
NEXT ENTR
07270D DCN7141
EXIT
EXIT
EXIT
EXIT
EXIT
EXIT