Table of Contents
Advertisement
Getting Started
3.2. VENTILATION CLEARANCE
Back of the instrument
Sides of the instrument
Above and below the instrument.
3.3. T200H/M LAYOUT
26
4. Inspect the interior of the instrument to ensure all circuit boards and other
components are intact and properly seated.
5. Check the connectors of the various internal wiring harnesses and pneumatic hoses
to make sure they are firmly and properly seated.
6. Verify that all of the optional hardware ordered with the unit has been installed.
These are checked on the paperwork (Form 04490) accompanying the analyzer.
Whether the analyzer is set up on a bench or installed into an instrument rack, be sure to
leave sufficient ventilation clearance.
AREA
Figure 3-1 shows the front panel layout of the analyzer, and Figure 3-4 shows the rear
panel with optional zero-air scrubber mounted to it and two optional fittings for the IZS
option. Figure 3-5 shows a top-down view of the analyzer. This configuration includes
the IZS option, zero-air scrubber and an additional sample dryer (briefly described in
Section 1.4).
Figure 3-1:
Teledyne API - Model T200H/T200M Operation Manual
MINIMUM REQUIRED CLEARANCE
10 cm / 4 inches
2.5 cm / 1 inch
2.5 cm / 1 inch
Front Panel
07270D DCN7141
Advertisement
Table of Contents
