Configuration Information (Cfg) - Teledyne 100E Instruction Manual

Model 100E Instruction Manual
Example: If all passwords are enabled, the following keypad sequence would be required
to enter the SETUP menu:
prompts for
password
number
Press individual
keys to set
numbers
Note that the instrument still prompts for a password when entering the VARS and DIAG
menus, even if passwords are disabled, but it displays the default password (818) upon
entering these menus. The user only has to press ENTR to access the password protected
menus but does not have to enter the required number code.

6.4.2. Configuration Information (CFG)

Pressing the CFG key displays the instrument configuration information. This display lists
the analyzer model, serial number, firmware revision, software library revision, CPU type
and other information. Use this information to identify the software and hardware when
contacting customer service. Special instrument or software features or installed options
may also be listed here.
045150102 Rev XB1
SAMPLE* RANGE = 500.000 PPB
< TST TST > CAL
SAMPLE ENTER SETUP PASS: 0
0 0 0
SAMPLE ENTER SETUP PASS: 0
8 1 8
SETUP X.X PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE
SAMPLE* RANGE = 500.000 PPB
< TST TST > CAL
SAMPLE PRIMARY SETUP MENU
DAS RNGE PASS CLK MORE
CFG
SAMPLE
M100E SO2 ANALYZER
NEXT PREV
Press NEXT of PREV to move through the
list of configuration information.
SO2 =X.XXX
SETUP
ENTR EXIT
ENTR EXIT
EXIT
SO2 =X.XXX
SETUP
Press EXIT at
any time to
EXIT
return to the
SAMPLE display
Press EXIT at
any time to
return to
EXIT
SETUP menu
Operating Instructions
Example: this
password enables the
SETUP mode
61