Table 6-1: T200H/M Preventive Maintenance Schedule - Teledyne T200H User Manual

ITEM ACTION
Particulate Filter Change filter
Review and
Verify Test Functions
evaluate
Evaluate offset and
Zero/Span Check
slope
Zero/Span Zero and span
Calibration calibration
Replace converter
NO Converter
2
& check efficiency
External, 2-stage
Zero Air Scrubber Exchange chemical
(Optional)
Reaction Cell Clean optics,
Window Change O-rings
Air Inlet Filter Of Change particle
Permeation Dryer filter
Pneumatic Sub- Check for leaks in
System gas flow paths
All Critical Flow
Orifice O-Rings & Replace
Sintered Filters
1
Pump Rebuild head
Inline Exhaust
Replace
Scrubber
PMT Sensor Low-level hardware
Hardware Calibration calibration
1
A pump rebuild kit is available from Teledyne API Technical Support including all instructions and required parts (the pump part number is on the label of the pump itself).

Table 6-1: T200H/M Preventive Maintenance Schedule

CAL MANUAL
FREQUENCY
CHECK SECTION
Weekly
No 6.3.1
(or as needed)
6.2; Appendix
Weekly No
Weekly -- 5.4, 5.6, 5.8
5.2, 5.5, 5.8,
Every 3 months --
5.9
Every 3 years or if Yes if CE
conversion efficiency factor is
< 90% used
Every 3 months
No 3.5.3.2
(or as needed)
Annually or as
Yes 6.3.5
necessary
Annually No 6.3.1, 6.3.2
Annually or after Yes on
repairs involving leaks, else 7.5.1, 7.5.2
pneumatics no
Annually Yes 6.3.6
Annually Yes 6.3.3.1
Annually No
On PMT/ preamp
changes & if Yes 7.6.4
0.7< SLOPE >1.3
C
--
--
DATE PERFORMED
07270D DCN7141 204