Teledyne T200H User Manual page 105

Teledyne API - Model T200H/T200M Operation Manual
Select which COM
port to configure
The sum of the mode
IDs of the selected
modes is displayed
here
Use PREV and NEXT to
move between available
modes.
A mode is enabled by
toggling the ON/OFF
button.
07270D DCN7141
Press the following buttons to select a communication mode for a one of the com ports,
such as the following example where HESSEN PROTOCOL mode is enabled:
SAMPLE
< TST TST > CAL
SETUP X.X
CFG DAS RNGE PASS CLK
SECONDARY SETUP MENU
SETUP X.X
COMM VARS DIAG
SETUP X.X
ID INET COM1
SETUP X.X
SET> EDIT
SETUP X.X
NEXT OFF
Continue pressing next until ...
SETUP X.X COM1 HESSEN PROTOCOL : OFF
PREV NEXT
SETUP X.X COM1 HESSEN PROTOCOL : ON
PREV NEXT ON
Continue pressing NEXT and/or PREV to select any other modes
you which to enable or disable
A1:NXCNC1=100PPM NOX=XXX.X
SETUP
PRIMARY SETUP MENU
MORE
ALRM
COMMUNICATIONS MENU
COM2
COM1 MODE:0
COM1 QUIET MODE: OFF
ENTR EXIT
OFF ENTR EXIT
ENTR EXIT
Operating Instructions
EXIT
EXIT returns
to the
previous
menu
EXIT
EXIT
EXIT
ENTR accepts the new
settings
EXIT ignores the new
settings
103