Table of Contents
Advertisement
Teledyne API - Model T200H/T200M Operation Manual
4.13.5.9. Setting Data Update Rate for an Analog Output
07270D DCN7141
The data update rate for the T200H/M analog outputs can be adjusted to match the
requirements of the specific DAS parameter chosen for each channel. For instance, if
the parameter NXCNC1 (NO
instrument set for dual gas measurement mode, it would be meaningless to have an
update rate of less than 30 seconds, since the NO
to complete. On the other hand, if the channel were set to output the PMTDET voltage
or the temperature of the moly converter, it might be useful to have output updated more
frequently.
concentration; Range 1) is chosen for channel A1 on an
x
-No measurement cycle takes that long
x
Operating Instructions
143
Advertisement
Table of Contents
