Teledyne T200H User Manual page 173

Teledyne API - Model T200H/T200M Operation Manual
SAMPLE
< TST TST > CAL
SETUP X.X
CFG DAS RNGE PASS CLK
EXIT returns
to the
SETUP X.X
previous
menu
COMM
SETUP X.X
Select which
COM Port is
ID
tested
4.15.2.7. COM Port Password Security
07270D DCN7141
To initialize the modem press:
A1:NXCNC1=100PPM
PRIMARY SETUP MENU
MORE
SECONDARY SETUP MENU
VARS DIAG ALRM
COMMUNICATIONS MENU
COM1 COM2
EXIT returns to the
Communications Menu.
In order to provide security for remote access of the T200H/M, a LOGON feature can be
enabled to require a password before the instrument will accept commands. This is done
by turning on the SECURITY MODE (see Section 4.9). Once the SECURITY
MODE is enabled, the following items apply.
•
A password is required before the port will respond or pass on commands.
•
If the port is inactive for one hour, it will automatically logoff, which can also be
achieved with the LOGOFF command.
•
Three unsuccessful attempts to log on with an incorrect password will cause
subsequent logins to be disabled for 1 hour, even if the correct password is used.
•
If not logged on, the only active command is the '?' request for the help screen.
•
The following messages will be returned at logon:
LOGON SUCCESSFUL - Correct password given
o
LOGON FAILED - Password not given or incorrect
o
LOGOFF SUCCESSFUL - Connection terminated successfully
o
To log on to the T200H/M analyzer with SECURITY MODE feature enabled, type:
940331 is the default password. To change the default password, use the variable
RS232_PASS issued as follows:
V RS232_PASS=NNNNNN
Where N is any numeral between 0 and 9.
NOX=XXX.X
SETUP
SETUP X.X
EXIT
SETUP X.X
<SET
EXIT
SETUP X.X
<SET
EXIT
SETUP X.X
<SET SET>
SETUP X.X
<SET SET> INIT
LOGON 940331
Operating Instructions
COM1 MODE:0
SET> EDIT
COM1 BAUD RATE:19200
SET> EDIT
COM1 MODEM INIT:AT Y∅ &D∅ &H
SET> EDIT
COM1 INITIALIZE MODEM
INIT
INITIALIZING MODEM
EXIT
EXIT
EXIT
EXIT
EXIT
171