Table 4-36: T200H/M Hessen Gas Id List - Teledyne T200H User Manual

Teledyne API - Model T200H/T200M Operation Manual
4.15.4.5. Hessen Protocol Gas ID
SAMPLE A1:NXCNC1=100PPM
< TST TST > CAL
SETUP X.X PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK
SETUP X.X SECONDARY SETUP MENU
COMM VARS DIAG ALRM
SETUP X.X COMMUNICATIONS MENU
ID HESN COM1 COM2
SETUP X.X HESSEN VARIATION: TYPE 1
SET> EDIT
Use the PREV & NEXT keys to cycle
existing entries in Hessen gas list
Use the PREV & NEXT keys to cycle
Toggle to change the gas ID number for the
Toggle to switch reporting Between ON and
07270D DCN7141
Since the T200H/M measures NOx, NO
installed), all of these gases are listed in the Hessen protocol gas list. In its default state
the Hessen protocol firmware assigns each of these gases a Hessen ID number and
actively reports all of them even if the instrument is only measuring one (see
MEASURE_MODE, Section 4.12).
To change or edit these settings press:
NOX=XXX.X
SETUP
MORE EXI
EXIT
EXIT
EXIT
through available gases
chosen gas.
OFF

Table 4-36: T200H/M Hessen GAS ID List

GAS DEFAULT
NOx
NO
NO
2
O
2
, NO and O
2
BUTTON FUNCTION
<PREV Moves to next gas entry in list
NEXT> Moves the cursor previous gas entry in list
INS Inserts a new gas entry into the list.
DEL Deletes the >>>>>.
ENTR Accepts the new setting and returns to the previous menu.
EXIT Ignores the new setting and returns to the previous menu.
SETUP X.X HESSEN RESPONSE MODE :CMD
<SET SET> EDIT
SETUP X.X HESSEN GAS LIST
<SET SET> EDIT
SETUP X.X NOX, 211, REPORTED
<PREV NEXT> INS DEL EDIT
SETUP X.X GAS TYPE NOX
<PREV NEXT>
SETUP X.X GAS ID: 211
0 0 0
SETUP X.X REPORTED : ON
ON
HESSEN GAS ID
211
212
213
214
Operating Instructions
(if the optional O
2 2
EXIT
EXIT
PRNT EXIT
ENTR EXIT
ENTR accepts the
new settings
EXIT ignores the
new settings
ENTR EXIT
ENTR EXIT
sensor is
177