Teledyne T200H User Manual page 69

Teledyne API - Model T200H/T200M Operation Manual
STEP 4 – O ZERO/SPAN CALIBRATION :
2
Analyzer continues to
cycle through NOx,
NO, NO
measurements
throughout this
The SPAN button now
appears during the transition
from zero to span.
You may see both keys.
If either the ZERO or SPAN
buttons fail to appear see
Section 10 for
troubleshooting tips.
07270D DCN7141
To perform the zero/span calibration procedure:
SAMPLE
NOX=XXXX
< TST TST >
SAMPLE
< TST TST >
Allow zero gas to enter the sample port
and O
2 2
SAMPLE
procedure.
< TST TST >
SAMPLE
NOX O2
SAMPLE
LOW HIGH
M-P CAL
<TST TST>
M-P CAL
<TST TST>
Allow span gas to enter the sample port
SAMPLE
< TST TST >
SAMPLE
NOX O2
SAMPLE
NOX O2
SAMPLE
LOW HIGH
M-P CAL
<TST TST> ZERO
M-P CAL
<TST TST>
M-P CAL
<TST TST> ENTR
The Model T200H/M analyzer is now ready for operation.
A1:CONC1=50PPM
CAL SETUP
Toggle TST> button until ...
O2 STB=X.XX % NOX=XXX.X
CAL SETUP
at the rear of the analyzer.
O2 STB=X.XX % NOX=XXX.X
CAL SETUP
GAS TO CAL:NOX
ENTR EXIT
RANGE TO CAL:LOW
ENTR EXIT
O2 STB=X.XX % NOX=XXX.X
ZERO CONC EXIT
O2 STB=X.XX % NOX=XXX.X
ENTR CONC EXIT
at the rear of the analyzer.
O2 STB=X.XX % NOX=XXX.X
CAL SETUP
GAS TO CAL:NOX
ENTR EXIT
GAS TO CAL:O2
ENTR EXIT
RANGE TO CAL:LOW
ENTR EXIT
O2 STB=X.XX % NOX=XXX.X
SPAN CONC EXIT
O2 STB=X.XX % NOX=XXX.X
ENTR CONC EXIT
O2 STB=X.XX % NOX=XXX.X
CONC EXIT
Getting Started
Set the Display to show
the O2 STB test function.
This function calculates
the stability of the O
2
measurement
Wait until O2 STB
falls below 0.1%.
This may take several
minutes.
Press ENTR to changes
the OFFSET & SLOPE
values for the O
2
measurement.
Press EXIT to leave the
calibration unchanged and
return to the previous
menu.
Wait until O2 STB
falls below 0.1%
This may take several
minutes.
Press ENTR to changes
the OFFSET & SLOPE
values for the O
2
measurement.
Press EXIT to leave the
calibration unchanged and
return to the previous
menu.
EXIT at this point
returns to the
SAMPLE menu.
67