Table of Contents
Advertisement
3. GETTING STARTED
3.1. UNPACKING AND INITIAL SETUP
The T200H and the T200M each weighs about 18 kg (40 pounds) without options installed. To
avoid personal injury, we recommend using two persons to lift and carry the analyzer.
Printed Circuit Assemblies (PCAs) are sensitive to electro-static discharges too small to be felt by
the human nervous system. Failure to use Electro-Static Discharge (ESD) protection when working
with electronic assemblies will void the instrument warranty. Refer to the manual, Fundamentals of
ESD, PN 04786, which can be downloaded from our website at
Help Center > Product Manuals in the Special Manuals section.
Note
Never disconnect electronic circuit boards, wiring harnesses or electronic subassemblies
07270D DCN7141
CAUTION – Avoid Warranty Invalidation
It is recommended that you store shipping containers/materials for future use
if/when the instrument should be returned to the factory for repair and/or
calibration service. See Warranty section in this manual and shipping procedures
on our Website at
http://www.teledyne-api.com
Authorization.
1. Inspect the received packages for external shipping damage. If damaged, please
advise the shipper first, then Teledyne API.
2. Included with your analyzer is a printed record of the final performance
characterization performed on your instrument at the factory. This record, titled
Final Test and Validation Data Sheet (P/N 04413) is an important quality assurance
and calibration record for this instrument. It should be placed in the quality records
file for this instrument.
3. Carefully remove the top cover of the analyzer and check for internal shipping
damage, as follows:
a. Remove the set-screw located in the top, center of the front panel.
b. Slide the cover backwards until it clears the analyzer's front bezel.
d. Lift the cover straight up.
CAUTION
WARNING
while the unit is under power.
http://www.teledyne-api.com
under Customer Support > Return
under
25
Advertisement
Table of Contents
