Teledyne T200H User Manual page 135

Teledyne API - Model T200H/T200M Operation Manual
SAMPLE A1:NXCNC1=100PPM
< TST TST > CAL
SETUP X.X PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK
SETUP X.X SECONDARY SETUP MENU
COMM VARS DIAG
SETUP X.X ENTER PASSWORD:818
8 1 8
DIAG SIGNAL I/O
NEXT
Continue pressing NEXT until ...
AIO Configuration Submenu
DIAG ANALOG I/O CONFIGURATION
PREV NEXT
07270D DCN7141
4. Choose an DAS parameter to be output on the channel.
5. Set the reporting range scale for the data type chosen.
6. Set the update rate for the channel.
7. Calibrating the output channel. This can be done automatically or manually for
each channel (see Section 4.13.6).
To access the analog I/O configuration sub menu, press:
NOX=XXX.X
SETUP
MORE EXIT
ALRM EXIT
ENTR EXIT
ENTR EXIT
ENTR EXIT
DIAG AIO A OUTS CALIBRATED: NO
<SET SET> CAL
DIAG AIO DATA_OUT_1: 5V, NXCNC1, NOCAL
<SET SET> EDIT
DIAG AIO DATA_OUT_2: 5V, NXCNC1, NOCAL
<SET SET> EDIT
DIAG AIO DATA_OUT_3: 5V, NXCNC1, NOCAL
<SET SET> EDIT
DIAG AIO DATA_OUT_4: 5V, NXCNC1, NOCAL
<SET SET> EDIT
DIAG AIO AIN CALIBRATED: NO
<SET SET> CAL
Operating Instructions
EXIT
EXIT
EXIT
EXIT
EXIT
EXIT
133