Table of Contents
Advertisement
QuickSpecs
Configuration Information - Factory Integrated Models
This section lists some of the steps required to configure a Factory Integrated Model. To ensure only valid configurations are
ordered, Hewlett Packard Enterprise recommends the use of an HPE approved configurator. Contact your local sales
representative for information on configurable product offerings and requirements.
1. Factory Integrated Models must start with a CTO Server.
2. FIO indicates that this option is only available as a factory installable option.
3. All Factory Integrated Models will be populated with sufficient hard drive blanks based on the number of initial hard drives
ordered with the server.
4. Some options may not be integrated at the factory. Contact your local sales representative for additional information.
Step 1: Base Configuration (choose one of the following configurable models)
[Chassis]
HPE ProLiant ML30 Gen9 Non-
hot Plug 4LFF Configure-to-order
SKU Number
Processor
DIMM Slots
Storage Controller
PCIe
Drive Cage
Network Controller
Fans
Management
USB
Step 2: Choose Required Options (only one of the following from each list unless otherwise
noted)
HPE Processors
Select one processor from Core Options-Processor section below.
For the Intel® C236 Chipset E3-1200 Series, the letter preceding the model number indicates the Product
Line (E3, E5, E7); 1200x v#, 1 is the number of CPU, 2 is socket type/segment designation, 00 = Processor
SKU, x = L for low power SKUs and v# (not yet designated) is the version number.
HPE Memory
Select one or more types of memory from Core Options-Memory section below.
Server
823401-B21
1
4LFF Non Hot Plug
iLO Management (standard), Intelligent Provisioning (standard)
•
Select one xxxxxx-L21.
•
Only one processor supported.
•
DDR4 speed is the maximum memory speed of the processor. Actual memory speed may depend
on the quantity and type of DIMMs installed.
•
HPE memory from previous generation servers is not qualified or warranted with this HPE
ProLiant Server.
•
HPE Standard Memory (UDIMM) is required to realize the memory performance improvements
and enhanced functionality listed in this document for this HPE ProLiant Server.
•
With one processor installed, four DIMMs slots are available.
•
Depending on the memory configuration and processor model, the memory speed would run at
HPE ProLiant ML30 Gen9 Hot
Plug 4LFF Configure-to-order
Server
823402-B21
1
4 DIMM slots for UDIMM DDR4 Memory
HPE Dynamic Smart Array B140i
4 PCIe 3.0 slots
4LFF Hot Plug
Broadcom 5720 Dual-port 1GbE
1 non hot plug, non-redundant
4 front, 4 rear, 2 internal
HPE ProLiant ML30 Generation9 (Gen9)
HPE ProLiant ML30 Gen9 Hot
Plug 8SFF Configure-to-order
Server
823403-B21
1
8SFF Hot Plug
Page 15
Advertisement
Table of Contents
