Removing The Terminal Blocks - IDEC FC4A-C10R2 User Manual

Removing the Terminal Blocks

• Turn off the power to the
Caution
vent electrical shocks.
• Use the correct procedures to remove the terminal blocks, otherwise the terminal blocks may be
damaged.
This section describes the procedures for removing the terminal blocks from slim type CPU modules FC4A-D20RK1 and
FC4A-D20RS1.
1. Before removing the terminal blocks, disconnect all
wires from the terminal blocks.
Remove the shorter terminal block on the left first,
then remove the longer one on the right.
2. When removing the longer terminal block, hold the
center of the terminal block, and pull it out straight.
3. Do not pull one end of the longer terminal block,
otherwise the terminal block may be damaged.
before installing or removing the terminal blocks to pre-
MicroSmart
First, remove the
shorter terminal
« FC4A M S U '
ICRO MART SER
3: I
NSTALLATION AND
block.
FC4A-D20RK1 and FC4A-D20RS1
M »
S ANUAL
W
IRING
Next, remove the
longer terminal
block.
3-5