IDEC FC4A-C10R2 User Manual page 159

Displaying and Clearing Error Data
This section describes the procedure for displaying general error codes and for clearing the general error codes.
1. Select the Error menu.
OK
Go to control
screen.
2. General error codes are displayed. Clear the general error codes.
Clear the general error codes.
Return to the Error menu.
For details about general error codes, see page 29-3.
Starting and Stopping the PLC
This section describes the procedure for starting and stopping the PLC operation using the HMI module.
Note: The procedure described below turns on or off start control special internal relay M8000 to start or stop the PLC oper-
ation. When a stop input is designated, the PLC cannot be started or stopped by turning start control special internal relay
M8000 on or off; the procedure described below does not work. See page 4-3.
1. Select the Run/Stop menu.
OK
Go to control
screen.
2. The PLC operation status is displayed.
OK
PLC operation status
RUN: Running
STP: Stopped
Current Status
3. Select RUN or STP to start or stop the PLC operation, respectively, using the ▲ or ▼ button.
Switch to
STP or RUN.
Slow Flash
OK
▲
Slow Flash
« FC4A M
To abort clearing the general error codes, press the ESC button
instead of the OK button; the Error menu is restored.
OK
Enable the
change.
Changed Status
S U ' M
ICRO MART SER S ANUAL
5: S
PECIAL
ESC
Return to the
Run/Stop menu.
»
F
UNCTIONS
5-39