IDEC FC4A-C10R2 User Manual page 111

Slim Type CPU Module (DC Power)
• Use a power supply of the rated value. Use of a wrong power supply may cause fire hazard.
Caution
• The allowable power voltage range for the slim type
DC. Do not use the
• If the power voltage turns on or off very slowly between 10 to 15V DC, the
and stop repeatedly between these voltages. If failure or disorder of the control system, damage,
or accidents may be caused, provide a measure for prevention using a voltage monitoring circuit
outside the
• Use an IEC 60127-approved fuse on the power line outside the
when equipment containing the
Power Supply Voltage
The allowable power voltage range for the slim type
Power failure detection voltage depends on the quantity of used input and output points. Basically, power failure is
detected when the power voltage drops below 20.4V DC, stopping operation to prevent malfunction.
A momentary power interruption for 10 ms or less is not recognized as a power failure at the rated voltage of 24V DC.
Inrush Current at Power-up
When the slim type CPU module is powered up, an inrush current of a
maximum of 50A flows.
Power Supply Wiring
Use a stranded wire of UL1015 AWG22 or UL1007 AWG18 for power
supply wiring. Make the power supply wiring as short as possible.
Run the power supply wiring as far away as possible from motor lines.
Grounding
To prevent electrical shocks, connect the
using a wire of UL1015 AWG22 or UL1007 AWG18. The grounding also
prevents malfunctioning due to noise.
Do not connect the grounding wire in common with the grounding wire of
motor equipment.
on any other voltage.
MicroSmart
MicroSmart.
MicroSmart
MicroSmart
terminal to a proper ground
« FC4A M S
ICRO MART
CPU module is 20.4 to 26.4V
MicroSmart
MicroSmart
is destined for Europe.
CPU module is 20.4 to 26.4V DC.
U ' M »
SER S ANUAL
3: I
NSTALLATION AND
may run
MicroSmart
. This is required
+ –
+
–
24V DC
W
IRING
3-17