IDEC FC4A-C10R2 User Manual page 389

3. Click the Configure button under the selected slots.
The Configure Parameters dialog box appears. All parameters for analog I/O control can be set in this dialog box. Avail-
able parameters vary with the type of the analog I/O module.
END Refresh Type Configure Parameters dialog box
FC4A-L03A1
FC4A-L03AP1
FC4A-J2A1
FC4A-K1A1
4. Select the type of the analog I/O module.
Click on the right of the analog I/O module Type No., then a pull-down list shows eight available modules.
Depending on the selected analog I/O module, other parameters available for the selected module are shown.
Ladder Refresh Type Configure Parameters dialog box
FC4A-J4CN1
FC4A-J8C1
FC4A-J8AT1
FC4A-K2C1
In the Configure Parameters dialog box, parameters in white cells are selectable while gray cells indicate default parame-
ters. In the white cells, optional values can be selected from a pull-down list or entered by typing required values.
Note for PID Instruction Source Operand S4 (process variable)
When using the PID instruction, specify the data register number shown under Data in the Configure Parameters dialog box
as source operand S4 (process variable) of the PID instruction. The analog input data in the selected data register is used
as the process variable of the PID instruction.
Analog I/O Data (Note)
Analog I/O Data (Note)
« FC4A M S U '
ICRO MART SER
24: A
M »
S ANUAL
I/O C
NALOG ONTROL
Analog I/O Operating Status
Analog I/O Operating Status
24-3