IDEC FC4A-C10R2 User Manual page 154

5: S F
PECIAL UNCTIONS
Selection of HMI Module Initial Screen
Special data register D8068 is available on upgraded CPU modules with system program version shown in the table below.
For the procedure to confirm the system program version of the CPU module, see page 29-1.
CPU Module
System Program Version
D8068 can be used to select the initial screen display of the HMI module when the CPU module is powered up.
Data Register
0, 2 through 65535
D8068
When a keep data error occurs, mode 1 is enabled regardless of the value stored in data register D8068.
Key Operation for Selecting Operand Number
When the OK button is pressed while a menu screen is shown, the screen switches to the control screen of the menu. For
example, while the timer menu is on the display, pressing the OK button switches the screen to the timer control screen,
where operand numbers and values are selected. For operation examples, see the following pages.
Timer Menu
OK Switches to the control screen.
ESC Discards the changes and
returns to the menu screen.
5-34
FC4A-C10R2
FC4A-C10R2C
203 or higher
Value
Mode 1: Indicates the PLC program version each time the PLC is powered up.
1 Mode 2: Indicates the same menu as when the PLC was shut down.
ESC Returns to slow flashing.
Fast Flashing
ESC Returns to fast flashing.
« FC4A M
ICRO
All-in-One Type
FC4A-C16R2 FC4A-C24R2
FC4A-C16R2C FC4A-C24R2C
202 or higher 202 or higher
Description
Slow Flashing
▲ Shifts up one digit.
▼ Shifts down one digit.
OK Selects the digit and changes to fast flashing.
▲ Increments the number.
▼ Decrements the number.
OK Saves the changes and goes to the next screen.
S U ' M
MART SER S ANUAL
Slim Type
FC4A-D20K3
FC4A-D20S3
202 or higher
»
FC4A-D20RK1
FC4A-D20RS1
FC4A-D40K3
FC4A-D40S3
201 or higher