Mounting On Din Rail; Removing From Din Rail; Direct Mounting On Panel Surface - IDEC FC4A-C10R2 User Manual

Mounting on DIN Rail

• Install the
Caution
Improper installation will result in falling, failure, or malfunction of the
• Mount the
Applicable DIN rail: IDEC's BAA1000PN10 or BAP1000PN10 (1000mm/39.4" long)
1. Fasten the DIN rail to a panel using screws firmly.
2. Pull out the clamp from each
and put the groove of the module on the DIN rail.
Press the modules towards the DIN rail and push in
the clamps as shown on the right.
3. Use BNL6 end clips on both sides of the
modules to prevent moving sideways.

Removing from DIN Rail

1. Insert a flat screwdriver into the slot in the clamp.
2. Pull out the clamps from the modules.
3. Turn the
MicroSmart

Direct Mounting on Panel Surface

MicroSmart modules can also be mounted on a panel
surface inside a console. When mounting a slim type
CPU module, digital I/O module, analog I/O module,
HMI base module, or communication module, use
optional direct mounting strip FC4A-PSP1P as
described below.
Installing the Direct Mounting Strip
1. Remove the clamp from the module by pushing the
clamp inward.
2. Insert the direct mounting strip into the slot where the
clamp has been removed (A). Further insert the direct
mounting strip until the hook enters into the recess in
the module (B).
modules according to instructions described in this user's manual.
MicroSmart
MicroSmart modules on a 35-mm-wide DIN rail or a panel surface.
module,
MicroSmart
MicroSmart
modules bottom out.
« FC4A M
Direct Mounting Strip
FC4A-PSP1P
S U ' M
ICRO MART SER S ANUAL
3: I
NSTALLATION AND
MicroSmart
(A)
(B)
»
W
IRING
.
Groove
35-mm-wide DIN Rail
Clamp
35-mm-wide DIN Rail
Clamp
3-7