Start/Stop Operation - IDEC FC4A-C10R2 User Manual

Start/Stop Operation

This section describes operations to start and stop the
• Make sure of safety before starting and stopping the
Caution
MicroSmart
Start/Stop Schematic
The start/stop circuit of the
three blocks; power supply, M8000 (start control spe-
cial internal relay), and stop/reset inputs. Each block
can be used to start and stop the
the other two blocks are set to run the
Start/Stop Operation Using WindLDR
The can be started and stopped using
MicroSmart
module. When the PLC Start button is pressed in the dialog box shown below, start control special internal relay M8000
is turned on to start the
1. Connect the PC to the
2. Check that a stop input is not designated using Configure > Function Area Settings > Run/Stop. See page 5-2.
Note: When a stop input is designated, the
nal relay M8000 on or off.
3. Select Online from the
The Download Program dialog box appears.
4. Click the PLC Start button to start operation, then the start control special internal relay M8000 is turned on.
5. Click the PLC Stop button to stop operation, then the start control special internal relay M8000 is turned off.
The PLC operation can also be started and stopped while
button, select Online > Monitor and select Online > PLC Status > Run/Stop Status.
Note: Special internal relay M8000 is a keep type internal relay and stores the status when power is turned off. M8000
retains its previous status when power is turned on again. However, when the backup battery is dead, M8000 loses the
stored status, and can be turned on or off as programmed when the
Configure > Function Area Settings > Run/Stop > Run/Stop Selection at Memory Backup Error. See page 5-3.
The backup duration is approximately 30 days (typical) at 25°C after the backup battery is fully charged.
may cause machine damage or accidents.
consists of
MicroSmart
while
MicroSmart
MicroSmart
. When the PLC Stop button is pressed, M8000 is turned off to stop the
MicroSmart
, start
MicroSmart WindLDR
MicroSmart
menu bar, then select Download Program. Or, click the download icon
WindLDR
« FC4A M
and to use the stop and reset inputs.
MicroSmart
MicroSmart
Power
Supply
.
run on a Windows PC connected to the
WindLDR
, and power up the
MicroSmart
cannot be started or stopped by turning start control special inter-
is in the monitor mode. To access the Start or Stop
WindLDR
MicroSmart
S U ' M
ICRO MART SER S ANUAL
4: O
PERATION
. Incorrect operation on the
Stop Reset
M8000
Input
Start Control
WindLDR
MicroSmart
. See page 4-1.
is powered up. The selection is made in
»
B
ASICS
Start
PLC
Input
CPU
.
MicroSmart
.
4-3