IDEC FC4A-C10R2 User Manual page 473

Monitor AS-Interface Slave
While the MicroSmart
Interface slaves can be monitored using
changed using
WindLDR
To open the Monitor AS-Interface Slaves dialog box, from the
menu bar, select
WindLDR
Parameter
Image
(PI)
Dialog Box
Monitor AS-Interface Slaves
Slave Status
Change Slave Output Statuses and Parameters
The output statuses and parameter image (PI) of the slaves connected to the AS-Interface master module can be changed.
To open the Slave Status dialog box, click the output of a required slave address in the Monitor AS-Interface Slaves dialog
box. Then, click the On or Off button to change the statuses of outputs DO0 through DO3 and parameters P0 through P3 as
required. Click to save the changes to the slave module.
Store
If the command is not processed correctly, the error message "AS-Interface Master Error" and an error code will appear.
See page 28-34.
The output statuses and parameters cannot be changed in the following cases.
Error Code
1
7
8
is communicating with AS-Interface slaves through the AS-Interface bus, operating status of AS-
WindLDR
.
, and select
Online Monitor AS-Interface Slaves
Button
Switch Slaves
Close
Help
Store
Close
•
An error was found on the expansion I/O bus.
•
The AS-Interface master module is in local mode.
•
Attempt was made to change the parameters of a slave which did not exist.
« FC4A M
28: AS-I
on a computer. Output statuses and parameter image (PI) can also be
menu bar, select
WindLDR
Switches between Slave A screen and Slave B screen.
Closes the window.
Displays explanations for functions on the screen.
Stores output statuses and parameters to the slave.
Closes the window.
Description
S U ' M
ICRO MART SER S ANUAL
M
NTERFACE ASTER
>
Online Monitor
in the pull-down menu.
Description
»
C
OMMUNICATION
. From the
28-33