Function Area Settings - IDEC FC4A-C10R2 User Manual

5: S
PECIAL
Introduction
The features special functions such as stop/reset inputs, run/stop selection at memory backup error, keep des-
MicroSmart
ignation for internal relays, shift registers, counters, and data registers. These functions are programmed using the Func-
tion Area Settings menu. Also included in the Function Area Settings are high-speed counter, catch input, interrupt input,
communication protocol selection for port 1 and port 2, input filter, and user program read/write protection.
This chapter describes these special functions. Clock function, analog potentiometer function, memory cartridge, and con-
stant scan features are also described in this chapter.
The Function Area Settings for communication functions are detailed in chapters 17 and 25 through 27.
• Since all Function Area Settings relate to the user program, the user program must be down-
Caution
loaded to the

Function Area Settings

Various special functions are programmed in the Function Area Settings. To call the Function Area Settings dialog box,
start on a Windows PC. From the
WindLDR
Area Settings dialog box appears.
Keep/clear designation for internal relays,
shift registers, counters, and data registers
Stop/reset inputs and run/stop
selection at memory backup error
Detailed information is described on the following pages.
F
UNCTIONS
after changing any of these settings.
MicroSmart
WindLDR
Normal input, two/single-phase high-speed
counter, catch input, or interrupt input
« FC4A M
ICRO
menu bar, select Configure > Function Area Settings. The Function
Communication mode setting for port 1 (maintenance or user
protocol) and port 2 (maintenance, user, modem protocol, or
data link master/slave communication)
Input filter, clock cartridge adjustment,
and user program read/write protection
Resets all Function Area Settings
values to defaults.
S U ' M »
MART SER S ANUAL
5-1