Teaching; Dtml (1-Sec Dual Timer); Dtim (100-Ms Dual Timer); Dtmh (10-Ms Dual Timer) - IDEC FC4A-C10R2 User Manual

22: D
UAL
Introduction
Dual timer instructions generate ON/OFF pulses of required durations from a designated output, internal relay, or shift
register bit. Four dual timers are available and the ON/OFF duration can be selected from 1 ms up to 65535 sec.
Teaching timer instruction measures the ON duration of the start input for the teaching timer instruction and stores the
measured data to a designated data register, which can be used as a preset value for a timer instruction.

DTML (1-sec Dual Timer)

DTML
*****

DTIM (100-ms Dual Timer)

DTIM
*****

DTMH (10-ms Dual Timer)

DTMH
*****

DTMS (1-ms Dual Timer)

DTMS
*****
Applicable CPU Modules
FC4A-C10R2/C FC4A-C16R2/C
—
/ T
EACHING
S1 S2 D1
***** ***** *****
S1 S2 D1
***** ***** *****
S1 S2 D1
***** ***** *****
S1 S2 D1
***** ***** *****
FC4A-C24R2/C
— —
« FC4A M
T
IMER
While input is on, destination operand D1 repeats to turn on
D2
and off for a duration designated by operands S1 and S2,
respectively.
The time range is 0 through 65535 sec.
While input is on, destination operand D1 repeats to turn on
D2
and off for a duration designated by operands S1 and S2,
respectively.
The time range is 0 through 6553.5 sec.
While input is on, destination operand D1 repeats to turn on
D2
and off for a duration designated by operands S1 and S2,
respectively.
The time range is 0 through 655.35 sec.
While input is on, destination operand D1 repeats to turn on
D2
and off for a duration designated by operands S1 and S2,
respectively.
The time range is 0 through 65.535 sec.
FC4A-D20K3/S3
—
S U ' M
ICRO MART SER S ANUAL
I
NSTRUCTIONS
FC4A-D20RK1/RS1 & FC4A-D40K3/S3
»
X
22-1