IDEC FC4A-C10R2 User Manual page 71

Analog I/O Module Terminal Arrangement and Wiring Diagrams
FC4A-L03A1 (Analog I/O Module) — Screw Terminal Type
Applicable Terminal Block:
FC4A-L03AP1 (Analog I/O Module) — Screw Terminal Type
Applicable Terminal Block:
FC4A-PMT11P (supplied with the analog I/O module)
•
Connect a fuse appropriate for the applied voltage and current draw, at the position shown in the
diagram. This is required when equipment containing the MicroSmart is destined for Europe.
•
Do not connect any wiring to unused terminals.
•
Before turn on the power, make sure that wiring to the analog I/O module is correct. If wiring is
incorrect, the analog I/O module may be damaged.
FC4A-PMT11P (supplied with the analog I/O module)
•
Connect a fuse appropriate for the applied voltage and current draw, at the position shown in the
diagram. This is required when equipment containing the MicroSmart is destined for Europe.
•
When connecting a resistance thermometer, connect the three wires to RTD (resistance temper-
ature detector) terminals A, B', and B of input channel IN0 or IN1.
•
When connecting a thermocouple, connect the two wires to terminals + and – of input channels
IN0 or IN1.
•
Do not connect any wiring to unused terminals.
•
Do not connect the thermocouple to a hazardous voltage (60V DC or 42.4V peak or higher).
« FC4A M
24V DC
– +
Analog voltage/current
input device
Analog voltage/current
output device
Analog voltage/current
output device
24V DC
– +
Analog voltage/current
input device
Resistance
thermometer
+
Thermocouple
–
S U ' M
ICRO MART SER S ANUAL
2: M
ODULE
Terminal No.
Fuse
+
–
+
+
–
–
NC
+
+
–
–
NC
+
+
–
–
Terminal No.
Fuse
+
–
+
+
–
–
A
NC A
B'
+ B'
B
– B
NC A
+ B'
– B
»
S
PECIFICATIONS
Channel
24V DC
OUT
IN0
IN1
Channel
24V DC
OUT
IN0
IN1
2-51