I/O Control; Applicable Cpu Modules; System Setup - IDEC FC4A-C10R2 User Manual

Fc4a series microsmart micro programmable logic controller

Table of Contents

Introduction

provides analog I/O control capabilities of 12- through 16-bit resolution using analog I/O modules.

This chapter describes the system setup for using analog I/O modules,

allocation numbers for analog I/O modules, and application examples.

For speciﬁcations of analog I/O modules, see page 2-43.

END refresh type analog I/O modules as many as listed below can be used with any FC4A

tem program versions.

Ladder refresh type analog I/O modules can be used with the FC4A

listed below.

All-in-one 10- and 16-I/O type CPU modules cannot use either END refresh or ladder refresh type analog I/O modules.

FC4A MicroSmart

Ladder Refresh

Quantity of Analog I/O Modules

I/O modules and analog I/O modules.

System Setup Example

Indicates the position where the expansion module is mounted. The slot number starts with 1 next to the CPU module up to

a maximum of 7.

CPU modules can be used with a maximum of seven expansion I/O modules, which include digital

Expansion I/O Modules (7 maximum)

All-in-One Type

204 or higher

programming procedures, data register

CPU module system program versions as

204 or higher

CPU module sys-

203 or higher

Show Quick Links

Table of Contents

Troubleshooting