IDEC FC4A-C10R2 User Manual page 70

2: M S
ODULE PECIFICATIONS
Analog Output Specifications
Category
Type No.
Output Range
Load Impedance
Load
Applicable Load Type
Settling Time
DA
Total Output System
Conversion
Transfer Time
Maximum Error at
25°C
Temperature
Coefficient
Repeatability after
Stabilization Time
Output Error
Output Voltage Drop
Non-lineality
Output Ripple
Overshoot
Total Error
Digital Resolution
Output Value
of LSB
Data
Data Type in
Application Program
Monotonicity
Current Loop Open
Maximum Temporary
Deviation during
Electrical Noise Tests
Noise
Resistance Recommended Cable
for Noise Immunity
Crosstalk
Isolation
Effect of Improper Output Connection
Selection of Analog Output Signal Type
Calibration or Verification to Maintain
Rated Accuracy
Note 1: Total input system transfer time = Sample repetition time + Internal processing time
When using the FC4A-J4CN1, FC4A-J8C1, or FC4A-J8AT1, the total input system transfer time increases in proportion to the
number of channels used.
Note 2: The data processed in the analog I/O module can be linear-converted to a value between –32768 and 32767. The
optional range designation, and analog I/O data minimum and maximum values can be selected using data registers allo-
cated to analog I/O modules. See page 26-12.
Note 3: When an error is detected, a corresponding error code is stored to a data register allocated to analog I/O operating
status. See page 26-6.
2-50
FC4A-L03A1
Voltage 0 to 10V DC
Current 4 to 20 mA DC
2 kΩ minimum (voltage), 300Ω maximum (current)
Resistive load
50 ms
Settling time + 1 scan time
±0.2% of full scale
±0.015% of full scale/°C
±0.5% of full scale
±1% of full scale
±0.2% of full scale
1 LSB maximum
0%
±1% of full scale
4096 increments (12 bits)
Voltage 2.5 mV
Current 4 µA
Default: 0 to 4095 (voltage, current)
Optional: –32768 to 32767 (selectable for each channel) (Note 2)
Yes
Not detectable
±3% maximum
(when a 500V clamp voltage is applied to the power supply and I/O lines)
Twisted pair shielded cable
No crosstalk because of 1 channel output
Between input and power circuit:
Between input and internal circuit:
No damage
Using programming software
Not possible
« FC4A M S
ICRO MART
END Refresh Type
FC4A-L03AP1 FC4A-K1A1
130 ms 50 ms
Isolated
Photocoupler-isolated
U ' M »
SER S ANUAL
Ladder Refresh
FC4A-K2C1
–10 to +10V DC
1 ms/ch
1 ms × channels
+ 1 scan time
±0.005% of full
scale/°C
±0.1% of full scale
50000 increments
(16 bits)
0.4 mV
0.32 µA
–25000 to 25000
(voltage)
0 to 50000
(current)
Twisted pair cable
2 LSB maximum