Calibration Mode; Figure 4-3: Viewing And Clearing T360 Warning Messages - Teledyne T360 Operation Manual

Operating Instructions
TEST deactivates warning
messages
NOTE:
If the warning message persists
after several attempts to clear it,
the message may indicate a
real problem and not an artifact
of the warm-up period
Figure 4-3:

4.3. CALIBRATION MODE

72
To view and clear warning messages:
SAMPLE SYSTEM RESET
TEST CAL
SAMPLE
< TST TST > CAL
SAMPLE
TEST CAL
Viewing and Clearing T360 WARNING Messages
Pressing the CAL button switches the T360 into multi-point calibration mode. In
this mode, the user can calibrate the instrument or check the instruments
calibration with the use of calibrated zero or span gases.
If the instrument includes either the zero/span valve option or IZS option, the
display will also include CALZ and CALS buttons. Pressing either of these
buttons also puts the instrument into multipoint calibration mode.

CALZ is used to initiate a calibration of the zero point.

CALS is used to calibrate the span point of the analyzer. It is recommended
that this span calibration is performed at 90% of full scale of the analyzer's
currently selected reporting range.
Because of their critical importance and complexity, calibration operations are
described in detail in Section 5 of this manual. For more information concerning
the valve options, see Section 3.6.
Teledyne API Model T360/T360M Operation Manual
CO2 = 0.00
MSG CLR
RANGE=500.000 PPM CO2 = 0.00
MSG CLR
SYSTEM RESET CO2 = 0.00
MSG CLR
SETUP
MSG displays warning messages.
SETUP
Press CLR to clear the current
message.
SETUP
If more than one warning is active, the
next message will take its place
Once the last warning has been
cleared, the analyzer returns to
SAMPLE mode
07272B DCN6552